H&S MINI MAX - Page 32

32 Mini Maxx Installation Manual • www.hsperformance.com
Overdrive Tuning Options
4-5th gear shift point adjustable up or down. Light to medium throttle, WOT is NOT adjustable.
5 levels:
1 – Lowest
2 – Stock shift point
3 – Medium
4 – Default
5 – Highest
5-6th gear shift point adjustable up or down. Light to medium throttle, WOT is NOT adjustable.
5 levels:
1 – Lowest
2 – Stock shift point
3 – Medium
4 – Default
5 – Highest
Line pressure. WARNING, only designed for built transmissions. The factory transmission pump is
NOT designed to be run more than 165-170 psi of pressure. Our current overdrive tune sets these
values to 170 psi (the pump mechanically will not supply more pressure, and will build excess heat
and waste energy). If they have a modied pump, they can use this adjustment to increase clutch
holding pressure. We have tested up to 250 psi with great results.
5 levels:
1 – Stock 160 psi
2 – Default 170 psi
3 – 200 psi
4 – 225 psi
5 – 250 psi
Shift Firmness. This adjustment will modify the acceleration rate between gear shifts. Making
them softer or rmer.
5 levels:
1 – Stock
2 – Light rm
3 – Default
4 – Firm
5 – Most rm
NOTE: An additional unlock fee may apply.
*Overdrive Transmission Software is not available on Cab & Chassis models.
Maxx Calibration Control
Maxx Calibration Control (MCC) is an advanced engine management software tool that enables
custom tune editing with your H&S tuning device. With the power to control all aspects of engine
and transmission management, MCC gives YOU the ability to control how YOUR engine operates!
2007.5 - 2009 6.7L Dodge Cummins Specic Features Continued >>