42
Tighten the nut crossly and symmetrically.
3. Checking the wheel attachments.
– Parking the truck securely.
– Tighten the wheel nuts crosswise with a
torque wrench.
Bolt tightening torque：
4. Check brake pedal
– Step the brake pedal, check it for slowness
or block .
– The proper brake distance is 2.5m when
free load .
– Adjust the height of pedal to 115～125mm .
– Adjust brake booster push rod clearance to
1-3mm .
– The brake lamp should be lighted when the
brake pedal steps on 10-20mm .
5. Check the parking brake lever
The force of hand brake lever is adjusted by
the bolt on the top of lever.
The force increases clock-wise screwing, and
decreases counter lock-wise screw.
CAUTION
To step the brake pedal is helpful to
tighten or loose the hand brake
lever.
6. Check accelerate pedal
The acceleration changes as the stroke
changes.
7. Brake fluid level check
Open the brake lubricated cap cover. Check
the fluid level in the range allowed. If lack,
please add, and check if there is air mix into
the pipe.
CAUTION
Please use brake fluid with one
type, do not mix.
Don’t spatter the brake oil onto the
surface of paint otherwise the paint
will be damaged.
When adding fluid, due should be
taken to prevent dirt or water from
entering the reservoir.
8. Check hydraulic oil
Loose the cap of hydraulic oil inside of right
frame, pull out dipstick and check it if the oil
level is between the scales. Add oil when lack.
To Next Page
Loading...
