46
stop the truck.
– Place the shift lever in neutral.
– Pull up the parking brake lever.
– Down the forks on the ground, tilt mast
forwards fully.
– Place the key switch in “OFF” to shut off
the battery. Remove the key and keep it.
CAUTION
Don’t dismount from the moving
truck, never jump from the truck.
Don’t parking the truck on the
working road.
Loading
– The forks should be adjusted properly to
maintain the balance of load.
– Place the truck right in front of the load to
be handled.
– The pallet should be evenly positioned
across both forks.
– Insert forks into the pallet as far as
possible.
– To raise loads from the ground：
– Firstly, lift the forks 5 to 10 cm off the
ground or floor and make sure loads lay
stably.
– Then tilt the mast backwards fully and lift
forks up to 15 to 20 cm off ground then
start running.
– When handling bulky loads which restrict
your vision, operate the truck in reverse
except when climbing grades.
Stacking load
– When approaching the deposit area slow
down your truck.
– Stop the truck right 30 cm far away from
the position where your load is to be
deposited.
– Check the condition of the deposit area.
– Tilt the mast forward until forks become to
horizontal. Raise forks until they are a little
higher than the deposit position.
– Move forward to place the load directly
over the desired area and stop the truck.
– Make sure your load is just over the
desired area. Slowly lower the load into
position. Make sure the load is securely
stacked.
– Do necessary lift-tilt operations and then
back away to make the forks leave loads.
To Next Page
Loading...
