41
9. Daily Maintenance
The earnest complete maintenance, can keep
the forklift to be at the good status. And the
safety of the truck is related with your job and
your life.
WARNING
Except checking lights and
operating capability, you should
shut off the key switch and pull out
the plug before checking electric
system.
Prohibit operate forklift with trouble.
Little trouble brings big accident.
1. Inspect oil leakage: include hydraulic oil,
electrolyte and brake fluid
Inspect connector of the oil pipe and storage
battery to see whether there is any leakage.
Use your hand or eyes to inspect, Forbid to
use a flame.
2. Inspect tire
Turn the tire valve cap counter clock-wise and
move it. Using a tire pressure gauge, measure
the inflation pressure, and adjusting it to the
specified pressure, if needed. After making
sure there is no air leakage from the tire valve,
reinstall the cap. Check that each tire does not
get damaged at the tread surface or side face.
Make sure the wheel felloe is not bended.
WARNING
Since the tires of forklift truck need
have a high inflation pressure to
carry heavy loads, even a small
bending of rims or a little damage at
the tread surface could cause an
accident.
When using an air compressor, at
first, adjust the air pressure of the
compressor. Otherwise it will cause
a serious accident, since the
maximum pressure of compressor
higher than the pressure tire can
bear.
Tire Pressure
Only for the pneumatic-tire(GB/T2982-2001)
WARNING
All bolts and nuts should be screw
tight to the stipulation torque after
the tire and the wheel felloe was
assembled, then charge is allowed.
Types have expansion energy after
changing, so the tire pressure does
not surpass the rating.
Please put the tire in a protection
frame or tie it with a iron chain when
charging to prevent accident
happening.
Replace tire
When the tire is damaged, you should replace
it in time. Use a jack to make the tire just
beyond ground, then put a wood block under
the chassis. Loosen nut , replace a new tire.
To Next Page
Loading...
