48
11. Deposit
Daily Depositing
– Park your truck at the area appointed, and
block the wheels to prevent accidental
roll.
– Make sure the shift lever on neutral
position.
– Pull up the hand brake lever.
– Shut off key switch and operate the lift
and tilt lever several times so that the
inner pressure in the hydraulic tube will
decrease.
– Cramp out the electrical outlet.
– Take out the key and deposit it in a safe
position.
Deposit the truck for a long time
On the basic of the “daily depositing” you
should do these checks and maintenance
additional:
– Take out plug to prevent discharge and
place in shade.
– Brush antirust oil on those parts which is
exposed such as piston rod and axle
easy-rusted.
– Cover breather hole and so on which
humidity easy to enter.
– Cover the whole truck with mantle
– All lubrication points add the oil (grease).
– Fill up the truck body and counter weight
with stow-wood to reduce bearing of the
two rear wheels.
– Operate the forklift once a week, and be
required to lift the forks to its max. height
many times .
– Check the proportion and the level of
electrolyte once a month.
– Charge the battery equally once a month.
WARNING
The stow-wood must be single and
hard enough to support the truck.
Don’t use a stow-wood higher than
300mm（11.81 inch）.
Lift the truck to the height of placing
on the stow-wood.
Place two same size stow-woods
under the left and right sides of the
truck.
After supporting the truck with
stow-wood, swings the truck
forward, backward, left and right,
check its safety.
Working after long deposit
– Get rid of antirust oil.
– Discharge the gear oil from driving axle,
decelerator box, and clean up the internal
of them. Add new oil.
– Charge the battery then install it to truck,
and do not forget to connect the
down-lead.
– Check carefully before starting, include
start, advance, and back off, turning, lift,
fall, tilt and so on.
To Next Page
Loading...