50
Measure in summer
In summer，water in the electrolyte is easy to
evaporate，therefore，electrolyte must often be
inspected if electrolyte is low，you must add
distilled water to the level appointed.
WARNING
Filling with distilled water beyond
the regulated range, Spilt electrolyte
will cause corrosion and electricity
leakage.
Measure in winter
– Keep effective and good surrounding for
charging.
– To prevent discharging ， when it is
cold ,pull out the battery pin.
– Take measures，such as，covering battery
for warmth.
– Charge in time after work.
Attentions for charging
– Please charge in the well-ventilated and
appointed site.
– Mark „no smoking‟ when charging.
– Inspect wire and electrical outlet.
– Before charging，please examine wire and
electrical outlet whether been damaged.
– Check connections whether there is
loosen, fasten if any.
– When wire or electrical outlet was
damaged，please do not charge.
– Open forklift cover and battery lid when
charging，in order to release the explosive
gas .
– In the progress of charging， electrical
source switch and battery pin are not to
pull out，otherwise will destroy pin and
electrical units. The normal procedure is
that: press down the stopping button
firstly，and then pick out the pin..
Charger
– The battery group is equipped with
JCD-35A-24 type automatic high
frequency computer to charge. The input
power supply is AC single-phase with
220V, input current is not lower than 15A.
The output voltage is DC36V and its max.
charge current is 35A. The charging
process is automatic, the detail of using
method please refer to the charger
operate manual.
– Connect with earth wire when the charge
is used.
– To replace fuse，make sure that the input
and output circuits are disconnected.
– Only professional person is allowed to
disassemble the cover to check and
repair.
– Do not rebuild or disassemble charger.
– In high temperature season, pay attention
to prevent the charge from destroy
caused by high temperature. Stop the
To Next Page
Loading...