3.Inspection of Operation
3.1 Appearance
① Lid: Lid protects the inside of the chamber and a rotor from coming out in danger
② Lid lock: This is a fixed part to keep the lid shut
③ RPM measuring window: This is a part measuring speed of rotor by a digital tachometer
④ Chamber: This is where a rotor is installed and it rotates
⑤ Lid packing : This packing is to prevent dew condensation from the outside for refrigeration
⑥ Rotor: This is connected to a spindle and rotates after you arrange tubes containing samples
⑦ Controller: This is where you can set up data such as RPM, TIME, Temperature and etc.
⑧ Power switch: This is where you can switch ON/OFF after you plug in
⑨ Emergency Lid Open system: This is where you can open a lid manually in case of emergency
3.2 Components
① Smart R17 Main body
② Power cable
③ User manual
④ Rotor Locking Tool (T wrench)
⑤ Extra fuse
⑥ Optional Components : Rotor and Accessory
※ ① ~ ⑤ : Built-in components
※ ⑥ : Optional Components, Purchase separately
⑩ Drain : This is where sample or water flowed into the chamber is discharged
such as power failure
To Next Page
