11
INSTALLATIONINSTALLATION
INSTALLATIONINSTALLATION
INSTALLATION
Materials Needed
• LDPE hose (7 meter/22 feet) (included) or other type of tubing
(Teflon
®
for example) more suitable for a specific application
(optional)
• Power cord (included)
Optional Accessories
• 4 each, ceramic weights (HI721008)
• 1 each, foot valve assembly (HI721005)
• 1 each, injection valve assembly (HI721004)
Location
A suitable location should:
• be near to a power source
• be conveniently close to the injection point
• allow easy access to the flow rate control and pipe or hose
connections
• be no more than 1.5 meters (5 feet) above the operating
position of the suction valve assembly.
Dimensions for Installation
BlackStone Pumps are designed for permanent installation.
The pump can be mounted directly on a wall or tank (see page 10 for
the specific mounting dimensions).
Power Requirements
BlackStone pumps are designed to operate to specifications within the
following voltage ranges:
100 - 130 Volts for 115V models
200 - 250 Volts for 230V models
Teflon
®
is a registered Trademark of "du Pont de Nemours & Co."
To Next Page
Loading...
Need help?
General
