ERROR MESSAGE & POSSIBLE SOLUTION
CABLE NOT CONNECTED :
1. Check whether the signal-cable is properly connected. If the connector is loose,
tighten the connector screws.
2. Check the signal-cable’s connection pins for damage.
INPUT NOT SUPPORT :
Your computer has been set to an unsuitable display mode. Set the computer to
a display mode from the table below:
FACTORY PRESET TIMING TABLE:
TIMING MODE
HORIZONTAL
FREQUENCY (kHz)
VERTICAL
FREQUENCY (Hz)
640x350 VGA-350 31.469 70.087
640x400 VGA-GRAPH 31.469 70.087
640x400 NEC PC9821 31.5 70.15
640x480 VGA-480 31.469 59.94
640x480 APPLE MAC-480 35.00 66.67
640x480 VESA-480-72Hz 37.861 72.809
640x480 VESA-480-75Hz 37.5 75
720x400 VGA-400-TEXT 31.469 70.087
832x624 APPLE MAC-800 49.725 74.55
800x600 SVGA 35.156 56.25
800x600 VESA-600-60Hz 37.879 60.317
800x600 VESA-600-72Hz 48.077 72.188
800x600 VESA-600-75Hz 46.875 75
1024x768 XGA 48.363 60.004
1024x768 COMPAQ-XGA 53.964 66.132
1024x768 VESA-768-70Hz 56.476 70.069
1024x768 VESA-768-75Hz 60.023 75.029
1024x768 APPLE MAC-768 60.24 75.02
1152x864 75Hz 67.50 75.00
1280x960 60Hz 60.00 60.00
1280x1024 VESA-1024-60Hz 64 60
1280x1024 VESA-1024-75Hz 80 75
1440x900 VESA-1440-60Hz 55.935 59.887
1440x900 VESA-1440-75Hz 70.635 75
To Next Page
Loading...
Need help?
General