Hanover DG3 - Page 29

DG3 Controller – Installation and Operation
Manual
540846-3 page 29 of 64 25/09/2015
The table below shows the three different settings for configuration parameter TV:
Value of
configuration
parameter: TV
Function
Refer to section
TV = 1
Set a fixed time
TV = 1 (for more details, please refer to
TV entry in Appendix E)
TV = 2
Use the countdown timer
TV = 2 (for more details, please refer to TV
entry in Appendix E)
TV = 3
Use the time function as a simple clock
TV = 3 (for more details, please refer to TV
entry in Appendix E)
 TV = 1 (for more details, please refer to TV entry in Appendix E)
How to set a fixed time:
Step
Description
Figure
1
Further to setting TV=1 in the DG3’s configuration, press
F/E key repeatedly until the following screen is shown.
The screen for the time is displayed as shown: hh:mm (in
24-hour format) for hours:minutes.
2
The hh will flash.
Use the up arrow key to increase the hh or the down
arrow key to decrease the hh.
Then, press F/E key to confirm your hours.
3
The mm will flash.
Use the up arrow key to increase the mm or the down
arrow key to decrease the mm.
Note: The left arrow key can be used to toggle between
hours and minutes at this stage if required.
Then, press F/E key to confirm your minutes.
Note: The time entered here will be substituted for any ‘~’ (tilde) character within the Helen destination or
driver display database. It is sometimes used by drivers ‘on the fly’ for entering departure times. The
destination message might thus be 'Bus departs at ~'.
Time:
00 : 00
Time:
1 1 : 00
Time:
1 1 : 14
The message generated in Helen for the sign must be in text mode for this function to work.