DG3 Controller – Installation and Operation Manual
540846-3 page 60 of 64 25/09/2015
Sets the quantity of advertising signs connected to the controller and causes their
addresses to be numbered immediately following the last-addressed destination
sign.
Note: This is not the preferred method of address-setting for the advert signs; it is
better done from within the Helen software, using the expression Sn=EX (where
n= the address number of the sign carrying the advertising message) in the
“Extensions” box (see section 7.2.8 of the Helen v3.3 display-editing software -
operating manual (ref. 540125)).
More than one expression can be used if more than one sign is showing the
advertisement; they should be separated by a comma.
advertising messages on the vehicle signs and
advert number prompt on the controller screen
1 = Browse to Idle is only allowed if RM = 1
2 = Browse to Idle is always allowed
destination browse to include destination 0000 and
route code 0000 to browse to Idle in route browse mode
Requires Destination to be enabled (DN=1) and is not available if ‘Route Browse’
enabled (RB=1).
With the up and down keys, all destinations can be scrolled through and selected.
Note: Do not confuse this code with that for bus reversing, which is set as an
external input option - please refer to section Displaying 'Bus reversing'.
Blanking timer in minutes (used with battery guard feature - please refer to section
Blanking the sign (battery guard).
0 = 100% (maximum brightness)
100 = 0%
Brightness limit of signs during BT-defined period (please refer to BT above)
following which, signs go blank - please refer to Blanking the sign (battery guard).
0 = does not prompt
1 = prompts
Prompts for selection confirmation when driver browses destinations in a route
To Next Page
Loading...