c) Disconnect the plug from the power source and/or remove the battery pack, if detachable, from the machine before making
any adjustments, changing accessories, or storing machines. Such preventive safety measures reduce the risk of starting the
machine accidentally.
d) Store idle machines out of the reach of children and do not allow persons unfamiliar with the machine or these instructions
to operate the machine. Machines are dangerous in the hands of untrained users.
e) Maintain machines and accessories. Check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the machine’s operation. If damaged, have the machine repaired before use. Many accidents are
caused by poorly maintained machines.
f) Keep cutting machines sharp and clean. Properly maintained cutting machines with sharp cutting edges are less likely to bind
and are easier to control.
g) Use the machine, accessories and machine bits etc. in accordance with these instructions, taking into account the working
conditions and the work to be performed. Use of the machine for operations different from those intended could result in a
hazardous situation.
h) Keep handles and grasping surfaces dry, clean and free from oil and grease. Slippery handles and grasping surfaces do not allow
for safe handling and control of the machine in unexpected situations.
Service
a) Have your machine serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety
of the machine is maintained.
Identifying hazards and risks
Identify hazards and risks, and take preventative steps to avoid accidents and minimise risk. Possible hazards include, but are not
limited to, moving parts, thrown objects, weight of chaff cutter and components, and the operating environment.
Below is a list of hazards and actions required to prevent injury.
Ensure that the belt guard is in place, and properly secured
by bolts with spring washers.
When performing maintenance on the machine, ensure that
it is disconnected from its power supply
Always wear safety glasses when operating the machinery
Do NOT look in to, or put your face near the outlet,
even when the machine is turned off
Do NOT put the machinery in a place where
material output might be obstructed
To Next Page