What to do if my Hanseatic HG4585C10T7636EI Dishwasher won't turn on?
If your Hanseatic Dishwasher isn't turning on, there are a couple of things you can check: * Make sure the mains plug is fully inserted into the socket. * Verify that the socket is supplying voltage by checking the fuse or plugging another device into the same socket.
Why won't my Hanseatic HG4585C10T7636EI Dishwasher start the selected program?
If the selected dishwashing programme on your Hanseatic Dishwasher won't start or stops, it could be due to a few reasons: * Ensure that the appliance door is properly closed. * Check that the water tap is fully turned on.
What to do if the Hanseatic HG4585C10T7636EI Dishwasher buttons are locked?
If you cannot operate your Hanseatic Dishwasher and suspect the buttons are locked, try unlocking them. Please refer to the “Button lock/Child lock” section on page EN-25 for instructions.
Why is water running slowly in my Hanseatic HG4585C10T7636EI?
If water is running slowly into your Hanseatic Dishwasher, check the following: * Ensure that there isn't a kink in the inlet hose. If there is, straighten it, referring to the section on “Connecting the inlet hose” on page EN-30. * Make sure the water tap is fully turned on.
What to do if Hanseatic HG4585C10T7636EI can be switched on/off, but cannot be operated?
If your Hanseatic Dishwasher can be switched on and off but not operated, ensure that the door is closed. The appliance can only be operated when the door is closed.
What to do if my Hanseatic HG4585C10T7636EI water is not draining properly?
If the water is not running off or is running off very slowly from your Hanseatic Dishwasher, consider these potential causes: * The filters may be blocked. Clean the filters, referring to the section on “Checking and cleaning the filters” on page EN-26. * The outlet hose might be kinked, extended, or hanging too high or too low. Ensure the outlet hose is properly laid out, as described on page EN-30.
Why is the LED illuminated on my Hanseatic HG4585C10T7636EI Dishwasher after adding salt?
If the LED is illuminated on your Hanseatic Dishwasher even after adding dishwasher salt, the salt might be clumpy. Try stirring the dishwasher salt using the end of a spoon or a similar utensil.
General| Brand | Hanseatic |
|---|---|
| Model | HG4585C10T7636EI |
| Category | Dishwasher |
| Language | English |
To Next Page