■ Allow the cooling unit to stand up-
right for 2 hours before start-up. The
lubricant will fl ow back into the com-
pressor during this time.
Improper handling of the appliance
can lead to property damage.
■ Do not pull or lift the appliance by
the doors.
■ The appliance must only be placed
on a level and fi rm surface. The sur-
face must be strong enough to sup-
port the appliance’s weight when ful-
ly laden.
■ Do not use sharp or pointed objects
to unpack it.
■ When unpacking the appliance, nev-
er damage the insulation material on
the back of the appliance.
■ Do not use any electrical parts inside
the appliance’s cooling chamber that
do not conform to the manufactur-
er’s recommended design.
■ Do not use any mechanical devices or
means other than those recommend-
ed by the manufacturer.
■ Do not insert any objects into the
back of the appliance and also make
sure that children cannot insert any
objects into the back.
■ The interior light must only be used
to illuminate the interior of the appli-
ance. It is not suitable for lighting a
room.
■ Do not store glass or metal containers
containing water, carbonated drinks,
beer, etc. Water expands when frozen
and can burst the container.
■ Do not use any means other than
those recommended by the manufac-
turer to speed up defrosting. For ex-
ample, do not use any electric heat-
ing equipment, knives or devices with
an open fl ame such as a candle. The
thermal insulation and the interior
are scratch and heat-sensitive and
can melt.
■ When cleaning, please note:
– Never use harsh, granular, soda,
acid, solvent-based or abrasive
cleaners. These attack the plastic
surfaces. All-purpose cleaners with
a neutral pH are recommended.
– Door seals and plastic parts are
sensitive to oil and grease. Remove
contaminants as quickly as possi-
ble.
– Use only soft cloths for cleaning.
■ Wait 5 minutes after switching off.
Only then switch the appliance on
again.
■ Only use original accessories.
SafetyPage EN-10
To Next Page
Loading...
Need help?
General
