What to do if my Hanseatic HWM6T214A2 is not pumping water?
If your Hanseatic Washer is not pumping water, check the outlet hose for clogs or bends and realign or dismantle if necessary. Also, inspect the lint trap for clogs.
Why is there too much foam in my Hanseatic Washer during the wash cycle?
Too much foam in your Hanseatic Washer during the wash cycle is usually caused by using too much detergent. Next time, try using less detergent. Also, ensure that the detergent you are using is suitable for washing machines.
What to do if my Hanseatic HWM6T214A2 Washer is leaking water?
If your Hanseatic Washer is leaking water, ensure that the inlet and outlet hoses are screwed on tightly. Also, check that the lint trap is closed properly.
What to do if my Hanseatic HWM6T214A2 is not receiving water?
If your Hanseatic Washer isn't receiving water, first check if the valve is closed and open it. Ensure the door is properly closed. Inspect the water inlet hose for any kinks and straighten it if necessary. If the water inlet hose is clogged, clean the water inlet hose filter. Also, check if the filter on the inlet is clogged.
What to do if my Hanseatic HWM6T214A2 wash cycle does not start?
If the wash cycle on your Hanseatic Washer isn't starting, ensure you've selected the desired wash cycle using the cycle selector. Make sure the door is properly closed until you hear it 'click' shut. Finally, press the Start/Pause button to initiate the cycle.
Why does my Hanseatic Washer appliance is unsteady or vibrating strongly?
If your Hanseatic Washer is unsteady or vibrating strongly, it might be due to several reasons. First, check if the transport security devices have been removed. If not, remove them. Ensure the appliance is installed and aligned properly. Also, if the laundry load in the drum is heavy or unevenly distributed, stop the washing and restart it to distribute the laundry more evenly.
What to do if my Hanseatic HWM6T214A2 Washer wash result is unsatisfactory?
If the wash result from your Hanseatic Washer is not satisfactory, consider the following: Ensure you are using enough detergent according to the manufacturer's instructions. If your water is hard, use the amount of detergent recommended for your area's water hardness. Avoid overloading the drum, and wash laundry at a higher water temperature or select another wash cycle if needed. Pre-treat stains with ox-gall soap or stain remover if necessary.
General| Capacity | 6 kg |
|---|---|
| Energy Efficiency Class | A+++ |
| Spin Speed | 1200 rpm |
| Noise Level (Washing) | 58 dB |
| Noise Level (Spinning) | 76 dB |
| Number of Programs | 15 |
| Weight | 62 kg |
To Next Page