12
3）Elongate the exhaust pipe and snap the flat end of the exhaust pipe joints into the
hole of the window sealing plate assembly (as shown in Fig.5 and Fig.6) .
Notes：
1、the flat end of the exhaust pipe joints must be snapped into place.
2、The pipe cannot be distorted nor has substantial turning (greater than
45 °). Keep the ventilation of the exhaust pipe not blocked.
Figure
5
Figure
6
Important notice:
The length of the exhaust hose shall be 280~1,500mm, and this length is based on the
specifications of the air conditioning. Do not use extension tubes or replace it with other
different hoses, or this may cause a malfunction. Exhaust host must be not blocked;
otherwise it may cause overheating.
VI.Drainage Instructions
This machine has two drainage methods: manual drainage and continuous
drainage.
1．Manual drainage:
1) When the machine stops after the water is full, turn off the machine power and
unplug the power plug.
Notes：Please move the machine carefully, so as not to spill the water in the
water pan at the bottom of the
EN
To Next Page
Loading...
