Hantek HDM3065 Series User Manual

35
 Measurements of connection changes after null operation
The temperature
This section describes how to configure 2 and 4-wire temperature measurements on
the front panel.
Step 1: Configure the test leads, as shown below.
2-wire temperature:
4-wire temperature:
Step 2: Press [Temp] on the front panel. The following menu will appear.
Step 3: Press Probe to select the probe type. If you choose to use an RTD, the menu
will have a soft key specifying the resistance of the RTD at 0℃ (R0).

Hantek HDM3065 Series Specifications

General

Brand	Hantek
Model	HDM3065 Series
Category	Multimeter
Language	English