Harbinger APS15 - Back Panel Connections; MIC Inputs; LINE Input; LINE Out

APS15
www.harbingerproaudio.com
1. MIC Inputs -TwoMICinputpairs.Eachoneacceptsahigh-impedance¼”jackand/oralow-impedance
XLRconnection.Forbestresults,usealow-impedancemicrophoneandaproperlywiredcable.
2. LINE Input -Acceptsline-levelsignalsthroughtheDualRCAjacksorthesingleXLRconnector.
3. LINE Out - Sends signal out before the power amp, for connection to another active speaker or any other
device that accepts a line level signal.
4. Power Switch -Switchestheunitonoroff.BesuretoturntheMASTERleveldownbeforeyouturnthe
unit on.
5. FUSE & AC -ThisisapowersocketwiththeFUSEholder.
Back Panel
3
1
2
3
4
5
CAUTION:
FIRE, REPLACE FUSE WITH THE SAME
TYPE AND RATING. DO NOT EXPOSE
THIS EQUIPMENT TO RAIN OR MOISTURE.
HOUSEHOLD USE ONLY
TO REDUCE THE RISK OF
MODELS:
FUSE:
AC~:
110V/120V~50/60Hz
APS15(S15QP-C)
T2A 250V
285VA MAX
AVIS: Ne pas ouvrir l'appareil!
Danger de décharge électrique!