Harbinger HA120 - Master Section Controls; Master EQ and Digital Delay Mix; Volume Control and Auxiliary Input; Audio Outputs and Footswitch Operation

HA120
www.harbingerproaudio.com
4
Master Section
1. MASTER EQ
LOW: This shelving control gives 15dB of boost or cut
at 80Hz and below.
MID: This is a band peak equalizer with a control range
of+/-15dBat1KHz.
HIGH: This shelving control gives 15dB of boost or cut
at 12KHz and above.
2. FX
This controls the signal from the input channels, processed
by the built-in digital delay.
FX MASTER: This knob adjusts the mix level of the
effect sound.
TIME: Turn this knob to the right to increase the interval
time between delays, to the left to decrease.
3. POWER INDICATOR
When the power switch at the rear panel is turned on,
this indicator will illuminate.
4. AUX IN CONTROL
This knob adjusts the level from the AUX Inputs to the
MasterVolume.
5 MASTER VOLUME
ThisknobadjuststhetotaloutputVolume.TurnMaster
Volumedownbeforeturningunitonoroff.
6 AUX IN & REC OUT
TheAUXINPhonoJacksallowMP3/CDplayerstobe
connected to the amplifier. The RECORD OUTPUT RCA
Phono Jacks provide signal output to audio equipment.
The nominal output level and impedance are
-10dBV/600ohms.
7 FOOTSWITCH
This jack accepts a footswitch (not included) to turn the
digital delay on or off. Compatible with momentary
footswitch (normal open circuit).
FOOT
SWITCH
AUX
IN
REC
OUT
HA12 0
120 WATT
4 CHANNEL MIXER
MID
FX MASTER TIME
DIGITAL DELAY
PEAKPEAK PEAK PEAK
125 WAT T S
AC 1 20V~50/60H Z 200W
INSE RT
MAI N
FUSE :2A
A
B
SPEAKE R
OU T
HA12 0
USE ONLY WITH 250V FUSE
1
3
2
4
5
6
7
1
2
3
6
4
5
7