Harbinger HA120 - Rear Panel Interface; Power, Speaker, and Insert Connections; Power Switch Functionality

Owner’s Manual
www.harbingerproaudio.com
5
Rear Panel
1. AC POWER SOCKET
Accepts the removable power cable.
2. POWER SWITCH
This switches the powered mixer on and off. While on,
the blue LED indicator on the front panel is lit.
3. SPEAKER OUTPUT JACKS
Connect both speakers to these jacks. The minimum
impedance load is 4 Ω. Do not connect more than two 8
Ω speakers or damage may occur.
4. MAIN INSERT
This unbalanced insert point is a break between the main
out and the built-in amplifier to allow the main output to
be sent to an external signal processor. The insert is a
1/4’’TRSphonejackwhichisnormallybypassed.When
a jack, such as the one below, is inserted, the signal path
is broken.
The main output signal appears on the TIP of the plug
and the external signal is returned on the RING. An
unbalanced1/4”insertcableisrequiredtoconnectto
equipment with separate send and return jacks as shown
below:
1
2
3
4
TIP SEND
SLEEVERETURN
INSERT
FOOT
SWITCH
AUX
IN
REC
OUT
HA120
120 WATT
4 CHANNEL MIXER
MID
FX MASTER TIME
DIGITAL DELAY
PEAKPEAK PEAK PEAK
125 W AT TS
AC 1 20V~50/60H Z 200W
INSE RT
MAI N
FUSE:2A
A
B
SPE AKER
OUT
HA120
USE ONLY WITH 250V FUSE
1
2
3
4
(not included)