Rear Panel
1. AC POWER
Power cable.
2. POWER SWITCH
This switches the powered mixer on and off. While on, the
power on blue LED indicator will light up on the master sec-
tion of front panel.
3. SPEAKER OUTPUT JACKS
Connect both speakers to these Jacks. The minimum
impedance load is 4 Ω. Do not connect more than two 8 Ω
speakers, or damage may occur.
4. MAIN INSERT
This unbalanced insert point is a break between the main out
and built-in amplier to allow the main output to be sent to
an external signal processor. The insert is a 1/4’’ TRS phone
jack which is normally bypassed. When a jack is inserted,
the signal path is broken.
The main output signal appears on the TIP of the plug and
the external signal is returned on the RING. An unbalanced
1/4” insert cable may be required to connect to equipment
with separate send and return jacks as shown below:
4
1
2
3
4
TIP SEND
SLEEVE RETURN
INSERT
1
2 3
4
To Next Page
Loading...
