Harbinger LX12 - Page 12

LX8 & LX12 OWNER’S MANUAL
12
31
MAIN OUTPUT LEVEL METERS
Display the main mix output level.
32
FX PRESET CONTROL AND LISTING
Selects the FX preset 1–24. The FX type for each preset can be seen
in the list above the knob.
33
FX SIG AND CLIP LEDs
These LEDs light up to give information about the incoming signal to
the FX processor. When there is signal present, the SIG LED will be lit,
indicating there is audio passing through the FX processor. If the CLIP
LED is lit at any time, the incoming audio is distorting and the resulting
FX will also be distorted.
34
FX MUTE SWITCH AND LED
Pressing this button mutes the FX return signal. When engaged,
the LED will illuminate.
35
MAIN OUTPUT LEVEL FADER CONTROL
This fader controls the level of the MAIN OUTPUT.
36
FX PRESET CONTROL AND LISTING
Selects the FX preset 1–8. The FX type for each preset can be seen
in the list above the FX Adjust knob.
37
FX ADJUST CONTROL
This control changes the characteristics of the selected FX preset
parameters allowing you to customize each preset.
38
FX LEVEL CONTROL
This control adjusts the overall level of the eected signal from the
FX processor that is being sent to the MAIN OUTPUTS.
39
MON MASTER CONTROL
Controls the combined send output level feeding the
MON OUTPUT.
40
DC POWER INPUT
Connect only the included power adapter to this input.
41
POWER SWITCH
Switches power on/o to the mixer.
42
USB PORT
Connect a standard USB type “A” to type “B” cable from the mixer
to a MAC or PC in order to record and playback audio from a
connected computer.