To Next PageTo Next Page
Need help?Do you have a question about the Harbor Freight Tools ICON 56683 and is the answer not in the manual?
General| Brand | ICON |
|---|---|
| Model | 56683 |
| Category | Tools |
| Type | Ratchet |
| Drive Size | 3/8 inch |
| Finish | Chrome |
| Teeth Count | 90 |
| Swivel Angle | 180 degrees |
| SAE/Metric/Torx | SAE |
| Quantity | 1 |
| Material | Steel |
| Head Design | Flex Head |
Wear ANSI-approved safety goggles during use.
Do not use the torque wrench for loosening fasteners.
Only use the torque wrench within its rated torque range.
Use the torque wrench only as intended, not as a hammer or pry bar.
Do not use handle extension to increase force or as a breaker bar.
Do not use a dropped torque wrench; test before putting back into use.
Have the torque wrench calibrated and serviced only by a qualified technician.
Inspect the torque wrench before every use for damage or loose parts.
Keep the torque wrench away from children.
Use only sockets with the correct drive and rating.
Handle batteries properly: do not mix types, ensure polarity, avoid damaged batteries.
Operator must use common sense and caution as manual cannot cover all situations.
Cycle through available Torque Units, Angle Mode, or Torque then Angle mode.
Press to turn on, hold 3 seconds to turn off. Auto-off after 2 mins.
Press to enter the menu.
Use to increase/decrease settings and navigate menu.
Used to reset values and set presets. Applied values cleared by hitting button.
In Torque Mode, LCD shows real applied torque. Applied value flashes, vibrates at set value.
In Angle Mode, LCD shows applied Angle Degrees. Wrench vibrates when set angle is reached.
Cycle to "T then A" mode. Wrench switches to Angle Mode after reaching preset Torque Value.
Lights turn red for values between 40% and 79.9% of preset value.
Lights turn yellow for values between 80% and 95.9% of preset value.
Lights turn green for values above 96% of preset value.
Press Menu Button to display menu. Use +/- buttons to move and Menu Button to select.
Change between Peak (records highest value) and Track (displays actual value) modes.
Set Calibration Reminder for Date (6/12 months) or Cycles.
Adjust Head Length, Backlight, Date/Time, LCD Contrast, Key Beep, Vibration, Sleep Time, Language, Decimal Mark.
Screen shows "OVER" if torque >110%. "REPAIR" if torque >150%.
Access "Over Info" via Menu to view Counter and Max Torque value.
Inspect for loose hardware, misalignment, cracked parts, or other safety issues.
Pull back Lock Ring, set to lowest torque, wipe with clean cloth.
Have the torque wrench calibrated and serviced by a qualified technician every 6 months.
