Harbor Freight Tools Predator 63584 - Starting the Engine: Electric Start and Break-in; Electric Start Procedure; Engine Break-in Period Details

Page 12
;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1
ITEM 63584
GH;6EI JK6LHEMJN OHMNE6NHNF6G6EPK
67*4$("4%G$,($
1. Move the Economy (ESC)
Switch to the OFF position.
2. Turn the Combination Switch
to the START position.
3. Press and hold the Starter Button
to start the Engine. If Engine
does not start within 3 seconds,
release Starter Button. Wait at
least 10 seconds, then try again.
N&$*- If engine does not start, check
engine oil level. Engine will not
start with low or no engine oil.
N&$*- If warm engine does not start,
turn Combination Switch to RUN
before trying to start it again.
4. The OUTPUT light illuminates when
the Engine starts and the Generator
produces power. Allow the Engine
to run for several seconds, then
move the Combination Switch
slowly to its RUN position.
N&$*- Moving the Combination
Switch too fast could stall the Engine.
MOKJLEHNE-%%Allow the Engine to run
at no load for five minutes after each
start-up so that the Engine can stabilize.
S(*,d?"8%K*("&9
a. Breaking-in the Engine will help to ensure proper equipment and Engine operation.
b. The break-in period will last about 30 hours of use.
DO NOT exceed 75% of the Generator’s running wattage during this period.
• Change the engine oil after this period.
Under normal operating conditions subsequent maintenance follows
the schedule explained in the OHMNE6NHNF6 section.
GE
HLE
J;;
LPN
l
6GF%EWLJEET6
JN
J;;
>
GEHLE6L
3
GE
HLE
J;;
LPN
O&]*%
G7&)7V
m