Harbor Freight Tools Predator 63584 - Connecting Loads to the Generator; 12 VDC Output Usage Guidelines; Connecting 120 VAC Loads

Page 13
;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1
ITEM 63584
GH;6EIJK6LHEMJNOHMNE6NHNF6 G6EPK
Nominal 12 VDC Output
1. Do not use any 120 VAC outlet
while using the 12 VDC outlet.
2. Move the Economy (ESC) Switch
to the OFF position.
3. Only use the 12 VDC receptacle
to charge a 12 volt lead-acid
type battery using an appropriate
charge controller. (Battery and
controller not included.) The
12 VDC output is not regulated.
4. Do not connect any device
to the 12 VDC terminal that
draws more than 8 amps.
5. If this 12 VDC circuit protection is
tripped, reduce the load, and press
the Reset Button next to the outlet.
F&88*4$"83%>li !HF%T&,9#%$&%$.*%R*8*(,$&(
F,74'7,$*%K&)*(%U(,)-
Power draw can be calculated by multiplying volts and amps. The resulting number is wattage.
• Never exceed the running wattage for the Generator or any outlet amperage rating.
• Refer to appliance/tool owner’s manuals to determine the wattage of electrical load devices.
• Long power cords and extension cords draw additional power. Keep cord length at a minimum.
Q,$$,3*%6#$"5,$*#
Refer to your device documentation for start-up and running wattage requirements.
Check nameplate wattages on all loads before connecting to Generator.
Plug the power cord of the 120 volt appliance/tool
into the 120 VAC Outlet on the Generator. Plug in
appliances from largest to smallest load.
N&$*-%U&%8&$%,77&)%$.*%R*8*(,$&(%$&%4&5/7*$*7V%('8%
&'$%&2%2'*7%)"$.%9*]"4*#%,$$,4.*91%%H%R*8*(,$&(h#%
&'$/'$%5,V%#.,(/7V%#/"d*%,#%"$%('8#%&'$%&2%2'*7=%
4,'#"83%9,5,3*%$&%,$$,4.*9%9*]"4*#1
;"3'(*%6-%%K7'3%T&,9%M8
6GF%EWLJEET6
JN
J;;
DC 12 V
8 A MAX
L6G6E