Page 14
;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1
ITEM 63584
GH;6EI JK6LHEMJN OHMNE6NHNF6G6EPK
J]*(7&,9%M89"4,$&(
N&$*- The OVERLOAD light may turn on for a few seconds as a large device starts up.
This is normal for loads approaching the capacity of this Generator.
1. The total combined load through the
outlet on the Generator must not exceed
the running power of the unit.
2. If the OVERLOAD light turns on and the Generator
stops producing power, it has been overloaded.
3. Turn off and disconnect all electrical devices and
stop the Engine. Compare device requirements
to Generator rating and reduce the total wattage
of connected devices if necessary. Move anything
that may be limiting Generator ventilation away.
4. Check if any circuit breakers have tripped
and make sure that ALL circuit breakers are
reset before starting the Generator again.
5. Restart the Engine and reconnect devices while
being careful to not overload Generator.
T&)%J"7%M89"4,$&(
1. If the Engine oil level is too low, the LOW OIL light
turns on and the Engine will automatically shut off.
2. The Engine cannot be restarted until the proper
amount of oil has been added. Add the appropriate
type of oil until the oil level is at the proper level.
SAE 10W-30 oil is recommended for general use.
NJEMF6-%%U&%8&$%('8%$.*%*83"8*%)"$.%$&&%7"$$7*%&"71%%
683"8*%)"77%#.'$%&22%"2%*83"8*%&"7%7*]*7%"#%$&&%7&)1
64&8&5V%^6GF_%G)"$4.
1. Turn the Economy (ESC) Switch ON to limit noise
and fuel consumption for lighter generator loads.
2. Turn the Economy (ESC) Switch OFF
to operate engine at full speed:
a. when starting
b. when a heavy load is applied
c. when using the 12 VDC output
U"3"$,7%U"#/7,V%G4(**8
The Display Screen can be used to monitor
the operating status of the Generator.
Use the Display Control Button to scroll
through the following indicators:
• V – Voltage
• A – Amperage
• VA – Volt Amps / Watts
• Hour – current run time and
accumulative run time
To Next Page
Loading...
