Time-Lapse Package
Revision E
Overview
The Time-Lapse Package is a complete system for documenting construction projects, animal behavior monitoring, analyzing
environmental changes, or other long-term outdoor photographic tasks.
This equipment will yield significantly higher resolution and higher quality images than can be achieved with “web camera”
equipment, and is designed to be completely autonomous... no connection to AC power, computers, networks, or video recorders are
needed. You own the equipment, and there are no monthly charges!
Except for a few mounting screws to suit your particular application, everything you need is included, and the system can be installed
in a as little as a few minutes.
Quick Start
1. Flip the toggle switch to the ON position. This will apply power to the camera and the controller.
2. Once the power is connected, the DigiSnap should immediately blink amber once, and then a few seconds later will quickly
blink four times green.
3. Turn the camera on, using the rotating power switch on the top of the camera.
4. Press the * button on the DigiSnap, and the camera should take a picture! This verifies that everything is connected and
working properly. Each time you press the * button, it should take a picture.
5. The DigiSnap controller is already configured at the factory to take pictures on a daily schedule. The following
configuration was used for testing, and you may want to reconfigure the settings for your application.
The DigiSnap is set to take pictures starting 1 minute after the power is turned on, and every day afterwards at the same
starting time. 10 Pictures will be taken per day, at an interval of 1 hour between shots.
Items included:
Fiberglass Housing, glass window.
High capacity internal battery pack.
5 Watt Solar Panel.
Harbortronics Solar Charger.
Harbortronics Battery Converter.
Harbortronics DigiSnap 2100.
Pentax K200D Digital SLR and 18-55mm Zoom lens.
A pair of 4 GB memory cards.
Hex wrench, cables, manuals and accessories.
Harbortronics Inc 3 10/7/2008
Here are all of the parts, before we assemble them!
To Next Page
Loading...
