3
IMPORTANT SAFETY INFORMATION
We at Harig Products, Inc. go to great lengths to make our products as safe as possible;
however, the possibility of injury still exists while operating machinery.
In virtually every case, injury is the result of:
Not knowing how to properly operate the machine.
Not following proper operating and safety procedures.
Carelessness or inattention.
Poor maintenance.
For your personal safety, and in order to get the maximum efficiency out of your new
Harig® Surface Grinder, carefully follow these guidelines:
NEVER operate the machine without safety glasses.
NEVER operate machine without the wheel guard in place.
DO NOT wear loose clothing, jewelry or any or other object that could become
entangled in the machine.
ALWAYS wait for the wheel to stop before bringing your hands to the table or
work piece.
MAKE CERTAIN work piece is SECURELY held in place.
NEVER attempt to hand hold or hand feed a work piece.
NEVER exceed the machine’s capacity.
Refer to the proper ANSI / OSHA Safety Codes for the care, use, and testing of
grinding wheels
Stop the machine and correct any malfunctions immediately (see Maintenance
manual or contact your supervisor).
Lock the table when you are not grinding.
Inspect and maintain the machine by a schedule.
If an electrical problem is suspected, contact a qualified maintenance individual.
Read your operations manual carefully before operating your machine.
THE FOLLOWING VIOLATIONS WILL VOID YOUR WARRANTY
Using anything other than Harig® Way Lube Oil™ (Single Gallon, Part No.
16211245)
Alterations to the following parts: CASTINGS, ELECTRICAL,
LUBRICATION, COOLANT and HYDRAULICS
Although reasonable care has been exercised in the preparation of Harig Products,
Inc. manuals to make them complete and accurate, they do not claim to cover all
conceivable circumstances or applications.
To Next Page
Loading...