5
Radial Winch 35.2 ST
Installation and Maintenance Manual
The winch can be installed following one of the two procedures below (Procedure1 or Procedure 2):
Procedure 1
To install the winch you must remove the drum and use Socket Head (SH) bolts.
Tools needed
One medium at-bladed screwdriver
To identify the various parts, refer to the exploded view at the end of this Manual.
Torque to apply when assembling
1. Unscrew the central screw ( 2Nm/18 in-lb)
3. Unscrew the three screws n°27
(
4Nm/35 in-lb)
2. Slide off the hub n°28 and the cover n°29
4. Remove the self-tailing arm n°26 by
rotating and lifting it.
To Next Page
