2005 PDI: CVO Models 7-7
FOOTREST ADJUSTMENT
If it is necessary to rotate rider or passenger footrests for cus-
tomer comfort, proceed as follows:
1. See Figure 7-8. Remove screw (2) and footrest rubber
insert (3) from footrest assembly (1).
2. See Figure 7-9. Loosen footrest adjustment screw.
Rotate footrest assembly to desired angle. Tighten screw
to 25.8 Nm (19 ft-lbs).
3. See Figure 7-8. Reinstall rubber insert (3) into footrest
assembly (1) and secure with screw (2). Tighten to 4.0-
6.0 Nm (35-53 in-lbs).
FINAL PREDELIVERY INSPECTIONS
Do not use sharp objects to peel protective film from
console insert and clutch release cover in the next two
steps. Sharp objects can scratch and damage finished
surfaces.
1. The airbox console insert is protected during shipment
by a clear plastic film. Carefully peel the film away from
the console insert.
2. The clutch release cover (righthand side of engine) is
protected during shipment by a clear plastic film. Care-
fully peel the film away from the clutch release cover.
NOTE
Perform all the remaining Predelivery Inspections given in
Section I (All Models) and Section VI (VRSC Models) that
apply to the VRSCA.
DO NOT REPEAT INSPECTIONS THAT WERE PER-
FORMED IN THIS SECTION.
Figure 7-8. Removing Footrest Rubber Insert
Figure 7-9. Footrest Adjustment Screw
1. Footrest assembly
2. Screw
3. Rubber insert
10772
3
2
1
10773
To Next Page