2005 PDI: CVO Models 7-17
FLSTFSE MODEL 7.3
GENERAL
CAUTION
The FLSTFSE model is shipped from the factory with
SYN-3
®
lubricant exclusively in the engine, primary and
transmission. If there is a need to top off lubricants, DO
NOT use standard lubricants and do not mix lubricants
as damage to the motorcycle can result.
Follow the instructions in section I (All Models) and Section IV
(Softail Models) and the following instructions to perform the
predelivery setup procedure on the FLSTFSE model.
This motorcycle is equipped with the Harley-Davidson Fac-
tory Security System and siren.
UNCRATING
See Figure 7-29. The FLSTFSE is shipped in a “turn-wheel”
crate which allows the handlebar to be shipped in position on
the handlebar risers.
Check Contents of Crate
Check that the following items are in a box in the crate:
● Seat
● Motorcycle cover
● Owner’s kit
● Right mirror
NOTES
● If any parts are missing, call 1-800-695-2925 or Fax 1-
717-852-6717. Provide your Dealer name, number, per-
son to contact, part number of missing item, and Motor-
cycle VIN.
● See Figure 7-30. After crating straps have been
removed, make sure to remove the plastic crating strap
bracket from the vehicle.
ADJUSTING HANDLEBARS
The FLSTFSE is shipped with the handlebars adjusted to a
standard riding position. If handlebars need to be adjusted for
more comfortable rider position, proceed as follows:
1. Loosen, but do not remove, all four handlebar riser clamp
screws.
2. Raise or lower handlebars to desired position. Make cer-
tain handlebars are centered side-to-side in risers.
3. Tighten two front handlebar clamp screws until top and
bottom risers meet (no gap in front). DO NOT tighten
screws to more than 15 ft-lbs (20.3 Nm).
4. Tighten rear handlebar clamp screws to 12-15 ft-lbs
(16.3-20.3 Nm).
5. Final tighten front handlebar clamp screws to 12-15 ft-lbs
(16.3-20.3 Nm).
Figure 7-29. FLSTFSE Shipped in Turn-Wheel Crate
Figure 7-30. Plastic Crating Strap Bracket
To Next Page