2005 PDI: Dyna Models 3-1
SPECIFICATIONS 3.1
TORQUE VALUES
The following torque values are included for fasteners that
may be loosened and tightened during Predelivery and
Setup. Any fasteners that are not loosened/removed do not
need to be checked during predelivery and setup.
2005 DYNA MODELS
SPECIFICATIONS
Idle Speed: 950 RPM at
Operating Temperature
Use 950 RPM during Predelivery and Setup adjustments.
Engine idle speed may increase during engine break-in. Use
idle speed listed in the Dyna Models Service Manual at Initial
Maintenance check.
NOTE
The idle speed on electronic fuel injected models can only be
set using a diagnostic tool such as DIGITAL TECHNICIAN
(Part No. HD-44750).
Table 3-1. Torque Values
ITEM TORQUE NOTES
Battery terminal screws 60-96 in-lbs 6.8-10.9 Nm
Front brake master cylinder cover screws 6-8 in-lbs 0.7-0.9 Nm
Handlebar clamp screws (front and rear) 12-18 ft-lbs 16.3-24.4 Nm
Mirror fasteners 12 ft-lbs 16.3 Nm
Clutch inspection cover screws 84-108 in-lbs 9.5-12.2 Nm
Table 3-2. Capacities
Component ENGLISH METRIC
Oil tank w/filter (Dry) 3 qt. 2.84 liter
Transmission (Wet) 20-24 oz 591-710 ml
Primary Chaincase 26 oz 769 ml
All motorcycles are shipped with 20W50 Harley-Davidson
360 Motor oil
1
To Next Page
Loading...