Harley-Davidson 2007 - Page 20

1.
2.
3.
HAZARD
WARNING
4.WAY
FLASHER
Use the following
method
to activate the
four-way flashers.
With the ignition
key
ON and
security
system disarmed
(models
with
security only),
press
the left
and right
turn
signal
swilches at the
same time.
Turn the
ignition key
OFF and
arm the
security system
if
present
and desired.
The four-way
flashers
will
continue
for two hours.
To
cancel four-way
flashing,
disarm the
security
system
if necessary,
turn
the ignition
key
ON and
press
the left
and right turn
signal
switches
at
the
same time.
This
system
allows a stranded
vehicle
to be left in
the four-way
flashing
mode
and secured
until help is found.
INDICATOR
LAMPS
See
Figure
4. Five indicator
lamps
are
provided.
.
The
green
TURN
indicators
will flash
when
turn signals
are
activated;therefore,
flashing indicates
the
chosen
turn
direction. When
the 4-way
hazard flashers
are operating,
both turn
indicators will
f lash
si
multaneously.
.
The blue BEAM
indicator
lamp, when
lit, signals
high
beam
headlamp
operation.
.
The
green
NEUTRAL lamp,
when lit,
signals
the transmis-
sion is in
neutral
gear.
.
The red
OIL indicator
lamp, when
lit,
signals that
oil is not
circulating through
the engine.
NOTE
The OIL indicator
lamp will
glow
when
the ignition
is turned
on
prior
to starting
engine. With
engine running,
lamp
should
be
off when
engine speed is
above idle.
Several
other circumstances
that
could
cause the red
oil
indicator lamp
to signal, include
the following:
.
lf the
oil
pressure
indicator
lamp
does not
go
off at
speeds
above idling,
it is
usually because
of an
empty oil tank
or
diluted oil.
.
In freezing
weather
the
oil
feed
may
clog with ice
and
sludge,
preventing
oil circulation.
.
A
grounded
oil signal switch wire.
.
A faulty
signal
switch
.
A
damaged
or
improperly
installed
check valve.
Trouble with the
pump.
lf the oil
pressure
indicator lamp
remains
lit, ahivays
check
the oil
supply first. lf the
oil supply is normal
and the lamp
is
still
lit,
stop the
engine at once
and do not ride
further
until the
trouble is located
and the
necessary repairs
are
made.
Failure to
do so may result
in engine
damage.
(00157a)
INSTRUMENTS:
TOURING
MODELS
Speedometer
Travel
at speeds
appropriate
for road
and
conditions
and
never
travel faster
than
posted
speed limit.
Excessive
speed
can cause loss
of
vehicle
control, which
could
result
in
death or
serious injury.
(00008a)
See
Figure
5.
The
speedometer
registers
kilometers
per
hour
(international
models)
or miles
per
hour
(U.S.
models)
of for-
ward
speed. The
speedometer
also
provides
the following
selectable functions:
.
Odometer
.
Trip
odometers
A
and
B
.
12 or 24 hour
clock
(if
radio not
instatted)
The
speedometer
has
a single
display window
for the
above
functions.
lf
an Advanced
Audio
System is installed,
the radio
will
provide
the clock function.
1.
See Figure
5. Pressing
the function
switch with
the ignition
switch in
any
position
will activate
the odometer
reading
and time.
Time and kilometers/mileage
may
be checked
without
unlocking ignition
switch. Press
and
release
func-
tion
switch once to view
odomeler.
Press
and release
switch again to
display time.
To check
mileage
on trip odometers,
the ignition
switch
must
be in the ACC
or IGNITION
position.
Press
and
release
the function
switch until the
desired trip
odometer
reading is
displayed.
An A
or
B in
the upper left
of the
display window
identifies
trip odometers.
To reset
or zero
trip odometers,
have
desired
(A
or
B)
odometer in
display window. Press
function
switch
and
hold
switch for 2-3
seconds. The
trip odometer will
be reset
to zero.
4. Repeat
the
previous
step
if
you
wish
to zero both
trip
odometers.
1.
Left turn
2.
High
beam
3. Neutral
4.
Oil
5. Riqht
turn
Figure
4. Indicator
Lamps
E-16
Controls and lndicators