5. See Figure 1-9. Install air filter cover (2).
a. Apply a drop of LOCTITE THREADLOCKER 243
(blue) to threads of air cleaner cover screw (1).
b. Install air cleaner cover and tighten screw to 36-60
in-lbs (4.1-6.8 Nm).
Figure 1-11. Element Gasket
EXHAUST SYSTEM LEAK CHECK
Check the exhaust system for leaks at every scheduled service
interval as follows:
1. Check entire exhaust system for loose or missing
fasteners, broken pipe clamps or brackets, and obvious
signs of leakage (carbon tracks at pipe joints, etc.).
2. Check for loose or broken heat shields. Repair or replace
as necessary.
3. Start engine, cover muffler ends with clean, dry shop
towels and listen for audible signs of exhaust leakage.
4. Correct any leaks detected. See 4.16 EXHAUST SYSTEM
for exhaust system removal and installation procedures.
1-16 2008 Dyna Service: Maintenance
To Next Page
Loading...