Tire sizes are molded on the sidewall. Refer to the tire fitment
tables below. Rim size and contour are cast or stamped into
the exterior surface of the rim.
Example: T19 x 2.15 MT DOT. "T" indicates that the rim con-
forms to Tire and Rim Association standards. The "19" is the
normal diameter of the rim in inches, measured at the bead
seat diameter. The "2.15" is the width of the bead seat meas-
ured in inches. "MT" designates the rim contour. "DOT" means
that the rim meets Department of Transportation Federal Motor
Vehicle Safety Standards.
Table 2-4.Tire Fitment - Tubeless Cast Wheels
Tire SizeRim Valve Hole Dia.Rim Size & ContourWheel Size & Position
Dunlop D427F0.327 in.E16 x 3.00 MT16 in. - Front
130/90B16 73H
Dunlop D401F0.327 in.T19 x 2.5 MT19 in. - Front
100/90-19 57H
Dunlop D4270.333 in.T16 x 5.0 MT16 in. - Rear
180/70B16 77H
Dunlop K5910.327 in.T17 x 4.5 MT17 in. - Rear
160/70B17 73V
Table 2-5.Tire Fitment - Tube Type Steel Laced Wheels
Tire SizeTube Size
Center Valve Tube
Rim Size & ContourWheel Size & Position
Dunlop D401FMJ/MM90-1919M/C x MT2.5 T19 in. - Front
100/90-19 57H100/90-19
Dunlop D402FMH90x2121 M/C x MT2.15 T21 in. - Front
MH90-21 54H
Dunlop K591150-160/70-1717M/C x MT4.5 T17 in. - Rear
160/70B17 73V
Table 2-6.Tire Fitment - Tube Type Chrome Aluminum Profile Laced Wheels
Tire SizeTube Size
Center Valve Tube
Rim Size & ContourWheel Size & Position
Dunlop D401FMJ/MM90-19T19 x 2.50 TLA19 in. - Front
100/90-19 57H100/90-19
Dunlop D402FMH90x21T21 x 2.15 TLA21 in. - Front
MH90-21 54H
Dunlop K591150-160/70-1717M/C x MT4.5 T17 in. - Rear
160/70B17 73V
Table 2-7.Tire Pressures: 2008 Dyna Models
TIRE PRESSURE (COLD)LOADMODEL
REARFRONT
kPaPSIkPaPSI
2483620630Solo riderAll models except FXDF
2754020630Rider and passenger
2483624836Solo riderFXDF
2754024836Rider and passenger
2-2 2008 Dyna Service: Chassis
To Next Page
Loading...