The glass used in your stove is manufactured to exact standards to withstand the high heat of the re, but
like all glass, it must be treated with common sense and care. Never abuse the glass by slamming the door
shut or striking the glass with a heavy object. If the glass is broken or damaged, do not operate the stove until
it has been replaced.
If the stove’s glass is cracked or broken, you must replace it before operating your stove. Remove pieces
carefully. Replace glass only with Harman replacement glass;
Carefully remove damaged glass, gasket material, and hold down clips (set aside).
Install the self adhesive 1/4"” gasket material around the front face of the glass. Set the glass panel and gasket
gently onto the door. Install the hold down clips and tighten with bolts.
Sometimes it will be necessary to clean accumulated ash from the glass surface; allowing this ash to remain
on the glass for long periods can result in “etching” due to the acidity of the ash. Never clean the glass while it
is hot, and use abrasive substances. Wash the surface with cool water, and rinse thoroughly. You may
wish to use a non-abrasive cleaner specically designed for use on stove glass. In any case, dry thoroughly
before relighting your stove.
: Ashes should be placed in a metal container with a tight tting lid. The closed container of
ashes should be placed on a non-combustible oor or on the ground, well away from all combustible materials,
pending nal disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should
be retained in the closed container until all cinders have thoroughly cooled.
Formation and need for removal. The products of combustion contain small particles of
y ash. The y ash will collect in the exhaust venting system and will restrict the ow of the ue gases. Pellet
fuels have different ash contents
When burning wood slowly, the potential exists for creosote to form. The venting system should be
inspected periodically throughout the heating season to determine if a creosote buildup has occurred. If a
signicant layer of creosote has accumulated (3mm or more), it should be removed to reduce the risk of
a chimney re. If a re occurs, call the re department, shut down the stove, and evacuate the residence.
Before using the appliance, have the venting system thoroughly inspected and replace any damaged
components.
Glass Gasket
Replace glass
only with high
t e m p e r a t u r e
ceramic glass.
Inspect door gasket during
cleaning and inspection
Fig. 57
To Next Page