Harman Kardon AVI150 - Operation; Amplifier Section; Tape Recording; Tape Dubbing

AMPLIFIER SECTION
1. Set the VOLUME CONTROL to the
extreme counterclockwise position.
2. Turn the power on.
3. Select the desired input function.
4. Play the input source.
5. Turn the VOLUME clockwise until
you reach the desired sound level.
TAPE RECORDING
1. Insert a blank tape in a cassette
deck (TAPE1 or TAPE2).
2. Select the desired input function.
For Tuner, tune in the desired station.
3. Set the cassette deck to recording
mode.
4. Play the input source. Recording
will start.
TAPE DUBBING
1. Insert a blank tape in cassette deck
2 (TAPE2).
2. Insert a recorded tape in cassette
deck 1 (TAPE1).
3. Select the input function of TAPE2
MON to monitor the sound (see #9
on page 7).
4. Set cassette deck 2 to recording
mode.
5. Set cassette deck 1 to playback
mode. Dubbing will start. NOTE: If
you press the TEST TONE button
during TAPE RECORDING or TAPE
DUBBING, the audio signal is not
recorded.
13
Operation
PROTECTION CIRCUITS
This amplifier has special protection
circuits.
@ The thermal overload protection
circuit automatically turns off the
power if it begins to overheat.
M The overdrive protection circuit
automatically turns off the power
if it is about to deliver too much
power.
The short protection circuit
automatically turns off the power
if the speaker terminals are
shorted.
If the amplifier shuts off check that the
ventilation holes on the top of the
amplifier are clear of obstructions and
check the speaker connections and
impedance.
harman/kardon
Surround
Off Hail
3-Stereo . Pro-Logic}
Center Level
Cent Mode © Test