Harman Kardon AVI150 - Input Function Selector; Center Level Up;Down Buttons; Center Mode Button; Test Tone Button

the batteries, make sure that the
polarity is correct. Remove the
batteries from the case if the remote
commander will not be used for a long
TUNER, TAPE 1, TAPE 2, TV/AUX, time.
9. INPUT FUNCTION
SELECTOR
Press the button to select the desired input
function. The available buttons are CD,
14. MASTER VOLUME
BUTTONS
Adjust the overall (front, center, and
rear) volume level.
VCR 1, VCR 2, and PHONO.
10. CENTER LEVEL
UP/DOWN BUTTONS
Use these buttons to adjust the sound
level of the center speaker to that of the
front speakers. These buttons work only
in Dolby, Pro Logic, and Dolby 3 Stereo
modes. These buttons do not work in
PHANTOM mode.
11. CENTER MODE BUTTON
Selects the center mode(see page 11/12).
12. TEST TONE BUTTON
Generates test sounds in all channels
(Left, Center, Right and Surround) in
succession.
13. REAR LEVEL UP/DOWN
BUTTONS
These buttons operate only in Dolby
Pro Logic, and HALL modes. Use these
buttons to adjust the sound level of the
surround speakers. Set the MASTER
VOLUME control at the desired level
and press the up or down button until
you get the optimum surround effect at
your listening position.
15
15. DISPLAY BUTTON
Press once and the display dims, press
again and it turns off. Press a third
time and it goes on.
16. SLEEP BUTTON
Sets the receiver to automatically turn
off after 10, 20, 30, 60, or 90 minutes.
Each time the button is pressed, the
setting is advanced as below.
[ 10 min > 20 min > 30 min > 60 min > 90 min > 7
The display will dim when the sleep
function has been set.
17. MUTE BUTTON
Press this button to silence the
speakers temporarily. The volume
indicator blinks. Press again to restore
the same listening level as before.
18. BATTERY
COMPARTMENT
This battery case is provided as the
power source for the commander. To
remove the cover, press it down with
your thumb and pull it toward the back
side. Two UM-3, size “AA” or R6 1.5V
dry batteries are used. When loading