14
MAIN REMOTE CONTROL FUNCTIONS
Soft keys: These buttons are used with some source devices.
See Table A13 in the appendix for details. They are also used with
a Teletext-capable television if your broadcast, cable or satellite
provider offers Teletext service.
Channel/Page Control: When the tuner has been select-
ed, this control selects a preset radio station. While operating a
cable, satellite or HDTV set-top box or a television, press these but-
tons to change channels.
Record Button: Use this button to make recordings when an
audio or video recorder is in use.
Setup Button: Press to display the AVR’s Main Menu, or to
switch the remote to AVR device mode.
Info Settings Button: Press to display the AVR’s Info
Menu, which contains the settings for the current source.
Source Settings Button: Press a Source Selector and
then this button to display a source device’s settings menu.
Zone Selector: Use this switch to select whether AVR
commands will affect the main listening area (Zone 1) or the remote
zone of a multizone system (Zone 2). For normal operation, leave
the switch in the Zone 1 position.
Track Skip: These buttons are used with source components
to change tracks or chapters.
Transport Controls: These buttons are used to control
source components and The Bridge III.
Light: Press to illuminate the buttons on the remote. Press it
again to turn the backlight off, or wait ten seconds after the last
button press for the light to turn off on its own.
Learn: The AVR 3600 remote is capable of “learning” individual
IR codes from the original remote that came with a source device.
See page 16 in the Installation section.
To Next Page
Loading...
Need help?
General
