Harman Kardon AVR20 II User Manual

13. VIDEO/AUDIO OUTPUT
(REC) JACKS OF VCR1
Connect these jacks to the
corresponding INPUT jacks of a VCR.
VIDEO OUTPUT jack: Connect this
jack to the VIDEO INPUT jack of the
VCR. VIDEO REC jack: Connect
these jacks to the AUDIO INPUT jacks
of the VCR.
14. VIDEO/AUDIO INPUT
(PLAY) JACKS OF VCR 2
Connect these jacks to the
corresponding OUTPUT jacks of your
VCR or VDP.
15. VIDEO MONITOR JACK
Connect this jack to the VIDEO INPUT
jack of a TV/MONITOR.
16. REMOTE CONTROL
OUT JACK
Connect this jack to the “REMOTE IN”
jack on a Harman Kardon component.
Use one of the accessory mini-plug
cables
You can control many other Harman
Kardon components in your system
using the AVR20 II remote commander.
17. MULTI-ROOM REMOTE
IN JACK
Connect a Harman Kardon HE 1000
remote |I.R. sensor to this jack. You can
operate the unit by remote commander
through the adapter. It is convenient
when the unit is located in a separate
room. (See page 10)
18. FRONT, CENTER,
REAR PRE OUT AND MAIN
IN JACKS
FRONT PRE OUT
When a separate power amplifier is
used to drive the front speakers,
connect the power amplifier input to
these jacks.
FRONT MAIN IN
When a separate pre-amplifier is
connected and this unit is used as a
power amplifier, connect the
pre-amplifier output to these jacks.
NOTE: When you do not use the PRE
OUT and MAIN IN separately, always
connect the PRE OUT and MAIN IN
jacks with a jumper plug.
CENTER PRE OUT
When a separate power amplifier is used
to drive the center speaker, connect the
power amplifier input to these jacks.
REAR PRE OUT
When a separate power amplifier is used
to drive the rear speaker, connect the
power amplifier input to these jacks.
19. 1/2 SPEAKER
TERMINALS
Connect the main left (L) and right (R)
speakers to the corresponding A and B
speaker terminals. Make sure that the
positive (+) and negative (-) terminals
on the speaker are connected to the
corresponding terminals on the receiver.
19A. CENTER SPEAKER
TERMINALS
Connect the corresponding positive
and negative terminals on the center
speaker to the positive (+) and
negative (-) terminals on the receiver.
20. REAR SPEAKER
TERMINALS
Connect rear speakers to the
corresponding terminals. When you
connect the rear speakers, connect
both L and R speakers.
21. AC INPUT CORD
Plug this cord in AC outlet on a wall.
22. AC Convenience
Receptacles
Other stereo components may be
plugged into the back of your receiver.
1. If a component is plugged into the
SWITCHED receptacle, power will be
supplied to that component only when
your receiver is turned on.
2. If a component is plugged into the
UNSWITCHED receptacle, power will
be supplied whether your receiver is on
or off.
NOTE: Do not connect any component
that requires more than 100 Watts of
power. Check the owner’s manual or
the back of the component to find it’s
power requirement.
23. SUBWOOFER OUT
When a separate power amplifier is
used to drive a subwoofer connect the
power amplifier inputs to these jacks.

Harman Kardon AVR20 II Specifications

General

Brand	Harman Kardon
Model	AVR20 II
Category	Receiver
Language	English