Note
:
Drill undersized holes in the car chassis so that the 5rnm tapping
Mounting to a Horizontal Surface with the Optional Brackets (BR1)
screws fit t~ghtly. We recommend
3
5mm or
118
inch diameter Using the template, locate and drill
6
holes corresponding to those in the short
holes.
ends of the vertical mounting brackets. Mount the brackets to the surface
Note
2:
A
template is enclosed so that the precise hole locations for the with the six 5mm hexagon-head tapping screws and spring washers. Then
tapp~ng screws can be easily determ~ned mount the
CA260
to the brackets using the six 5mm hexagon-head nuts and
bolts.
,Tern plate
Directly Mounting to a Vertical Surface
Using the template, locate and drill
6
holes corresponding to those
In
the
CA260
chass~s Securely mount the
CA260
to the surface with the six 5mm
hexagon-head tapping screws and sprlng washers
Spr~ng Washer
,&!$%a
Vertical
Mounting
.
Spring Washer
To Next Page
Loading...
