Two CA260's can be used with two woofers (low frequency speakers) and
two mid-high (or full-range) speakers to make up an "active" system, both
amplifiers bemg drwen by the same tunerldeck. This type of system is con
nected as follows.
1
Set the filter onloff switch of one CA260 to the
"on" position. Then set the high passllow pass
switch to the "low pass" position Connect the
FILTER
woofers (low frequency speakers) to thrs
amplifier
2.
Set the filter onloff switch of the other CA260 to
the "on" position Then set the h~gh passllow
pass switch to the'lhigh pass" position Connect
the mid-high (or full range) speakers to this
ampl~fier
3.
Connect the left channel input jacks of each ampl~fier to the left channel
output of the tunerldeck. Connect the right channel input jacks of each
amplifier to the r~ght channel output of the tunerldeck
Note: If the tonal balance seems to be favoring either the high or low
Ire-
quency range, try using different line input sensitivity switch positions to make
the best balance. For example, if the sound is bass heavy, set the line input
sensitivity switch for the "low pass" amplifier to the "low" pos~tion. This
will reduce the signal to the woofers
200Hz
LOW
PASS HIGH PASS
Right channel
(pJ
Left channel
Speaker System
/
\
Right
channel
12dBloctave 6dBioctave
Left
channel
Right channel
ou~put
.-
-
Left
channel
output
TunerlDeck
To Previous Page
Loading...
