Page 3
Setup
Carefully unpack your speaker system and identify all components:
• Control/Right Satellite speaker
• Auxiliary/Left Satellite speaker
• Subwoofer with attached power and audio input cables
Connect the speaker system as shown in the Connecting the speaker system to sound card
illustrations. Once the speaker system is properly connected, turn on the power switch located on the
rear of the subwoofer.
Step 1 Connecting the speaker system to the computer. If you have an integrated sound solution or
a stereo sound card (as shown on page 4 and 5); connect the green connector from the subwoofer
into the green jack on the computer, the black connector is not used, leave the rubber cap on the
black connector to prevent static from the pin grounding on the system. If you have a multi-channel
sound card (as shown on page 6); connect the green connector from the subwoofer into the green
jack on the computer and connect the black connector from the speaker into the black jack on the
computer. If you have a portable computer (as shown on page 7); connect the green connector from
the subwoofer into the headphone jack on the computer, the black connector is not used, leave the
rubber cap on the black connector to prevent static from the pin grounding on the system.
Step 2 Plug the orange connector from the right/control satellite into the orange jack on the
subwoofer.
Step 3 Plug the brown connector from the left satellite into the brown jack on the subwoofer.
Step 4 Plug the AC plug into the wall outlet.
Step 5 Turn on the speaker set and adjust the volume accordingly.
To Next Page
Loading...
