Page 9
Using the speaker system
On/Off Switch
An on/off switch is located on the rear of the subwoofer.
There is a green LED located on top of each of the two satellite speakers. There is also a green
LED located on the top of the subwoofer. All three LEDs should illuminate when the system is
connected correctly and receiving power.
Turn the speaker off if it will not be used for a long period.
Volume Control
The volume control can be found on the top of the control/right satellite speaker.
Pushing the right + button on the top of this speaker will turn up the volume setting in increments
of 2.0 dB per step. If the button is continuously depressed, after 0.5 seconds the volume level will
constantly increase at a rate of 20 dB per second.
Pushing the left - button on the top of the right speaker will turn down the volume setting in
increments of 2.0 dB per step. If the button is continuously depressed, after 0.5 seconds the
volume level will constantly decrease at a rate of 20 dB per second until the system is muted.
The harman/kardon HK 695 will retain the volume setting when it is turned off so that when the
speaker system is turned back on, it will restore the last volume setting.
Muting
Pushing the left and right buttons simultaneously on the top of the right speaker will mute the
audio. Power will remain on (both speakers’ LED’s remain illuminated). When muted, pushing
either the left button or the right button, or both buttons simultaneously will restore volume to the
level prior to the activation of the mute function.
To Next Page
Loading...
