Citation 7.0 Owner’s Manual
Preliminary Draft
Page # 63
Enitre Contents Copyright ©1995 - Harman Kardon Inc.
To adjust the ambiance level in your custom venue, start at the main Venue Edit menu, and press the “Г button so
that the on screen Ö pointer is on the bottom line next to “Ambiance”. Press “select” to move to the next menu screen.
At the “Adjust Ambiance” screen (figure #xx) a slider scale will appear. Use the ”Γ and “Í“ buttons to enter a desired
ambiance level. When you have entered the amount, press “Exit/OK” to enter the setting and return to the Custom
Venue Edit menu.
NOTE: In order to complete the creation of a custom venue, you MUST enter some ambiance. Even though
this can be as little as “01” on the sliding scale, some ambiance must be included as part of the settings, or the venue
will not be recorded to memory.
Entering A Custom Venue
At this stage you will have adjusted each of the five components of a custom venue. You may return to any of the
settings before completing the process by using the “Ï“ and “Г buttons to select the item to be fine tuned. Follow the
directions shown above to adjust any of the individual items.
When all adjustments are completed, press “Exit/OK”. IF you wish to cancel the settings and ignore the setup, press
“Cancel” to return to normal operation without entering the settings to memory. To SAVE the settings as a custom
venue, press “Select”.
NOTE: Once a custom venue has been created, it is also available to be called up during any listening session
by pressing the “Venue” button on the remote. The venue settings created by the process described above will appear
as the “Custom Venue” choice on all menus.
Edit Name
Once you have entered all the settings that will be used to create the new surround mode, you will want to give it a
name. Although the mode will continue to be called back by using one of the “Custom” buttons on the remote, giving
the mode a name will personalize it for you.
To give a new name to a mode, start at the “Surround Mode Edit” menu, and then press “Г until the on screen Ö
pointer is next to “Edit Name” (figure #xx). Press “Select” to continue.
At the “Name Edit” menu you change the name that is preset with any ten character entry that you choose. To change
the name, press “Í“ and “Γ to move the Ç pointer under the letter you wish to change. (Figure #xx). Press the “Г
and “Ï“ buttons on the remote to scroll through the list of alphanumeric characters. When the desired character
appears, press “Í“ and “Γ to move the Ç pointer under the next character to be changed.
When the mode name is complete, press “exit/OK” to return to the Surround Mode Edit menu.
To Next Page
Loading...
