Harman Kardon HK1200 - Controls and Functions; Power Switch and Indicator; Tape Monitor and Source Selectors; Volume and Gain Controls

HK1200/HK1400
ALIGNMENT PROCEDURES (REFER TO PAGES 13,15,16 AND 19)
@ Conditions : - Set the Source selector to the "CD" position.
« Set the Valume control to minimum.
+ Make the adjustment at a room temperature of 77°F (25°C)
I DC BALANCE ADJUSTMENT
Connect the Digital Volt Meter to Speaker output. VR403
Connect the Digital Volt Meter to Speaker output. VR404
WH IDLING CURRENT ADJUSTMENT
Connect the Digital Volt Meter to TP401 and TP402. VR401
Connect the Digital Volt Meter to TP403 and TP404. VR402
BLOCK DIAGRAM
SOURCE TAPE
SELECTOR "MONITOR VOLUME
O SPEAKER