OPERATION 15
Operation
Using the Remote Control
It is convenient to think of the functions of the
remote control buttons in terms of “pages”,
where each source device (e.g. CD player) repre-
sents its own page of remote functions. The
result is that some of the keys will perform dif-
ferent functions depending upon which device
page has been selected prior to pressing the
key. Device pages are selected by pressing the
Source Selectors ç, which also changes the
input source selection on the HK 3370.
Source Selectors ç need not to be pressed
with each function, but only when you intend to
skip to another device to be controled.
Three of the device pages are factory-
programmed to operate compatible
Harman Kardon products. The Tape Monitor
device page is programmed as a factory default
to operate Harman Kardon cassette decks. The
Tape 2 page defaults to Harman Kardon CD-R
control codes. The CD page defaults to
Harman Kardon CD player or changer control
codes. Please refer to the table below for specif-
ic information on the default functions of the
affected keys for these devices.
BUTTON TAPE MON TAPE 2 CD
Cassette deck control codes CD Recorder control codes CD player/changer control codes
PRESET DWN ∂ REV. SKIP SKIP BACK REV. SKIP
PRESET UP ∂ FWD. SKIP SKIP FORWARD FWD. SKIP
TUNING DWN † REW REV SEARCH REV SEARCH
TUNING UP † FF FWD SEARCH FWD SEARCH
Rec./Pause •/B ì REC / PAUSE RECORD PAUSE
Stop A ì STOP STOP STOP
Rev. Play F ì REV. PLAY RANDOM PLAY
Fwd. Play G ì FWD. PLAY PLAY PLAY
DISK SKIP Up ƒ DISC SKIP UP
DISK SKIP Down ƒ DISC SKIP DOWN
FM MODE ß TIME Display (Record Deck)
PRESET SCAN œ INTRO SCAN INTRO SCAN (Play Deck)* INTRO SCAN
TUNING Up D î CDP SELECT
TUNING Down E î CDR SELECT
MEMORY ø PROGRAM PROGRAM
AUTO PRESET ¬ FINALIZE
CLEAR Ñ CLEAR CLEAR
1 ˚ 11 1
2 ˚ 22 2
3 ˚ 33 3
4 ˚ 44 4
5 ˚ 55 5
6 ˚ 66 6
7 ˚ 77 7
8 ˚ 88 8
9 ˚ 99 9
0 ˚ 00 000
REMOTE BUTTON FUNCTIONS
* not with CDR2/20
To Next Page
Loading...
