Harman Kardon HK6250 - Connections; Connecting Other Components; Connecting Speakers

Speaker System 1
Right channel Left channe
2)
Fae
mga
$000
——|
Compact Disc Player
Connecting Other Components
Carefully
connect
the
plugs
to
the
left
and
right
channel
jacks.
Push
the
plugs
in
all
the
way.
Poor
setting
of
the
plugs
tends
to
cause
hum
or
intermittent
sound
and
may
damage
the
speakers.
NOTE:
While
you
are
connecting
this
unit
to
the
rest
of
your
high
fidelity
system,
please
unplug
the
power
cord,
discon-
necting
not
only
this
unit
but
all
the
components,
from
the
AC
outlet.
Do
not
interwind
the
connection
wires
with
the
power
cord.
if
interwound,
the
sound
quality
may
be
degraded.
Connecting Speakers
Connect
the
speaker
wires
carefully
to
the
speaker
terminals
on
the
rear
panel
so
as
not
to
mistake
the
left
and
the
right
channels
or
reverse
the
speaker
polarities
(+
and
-).
Use
sufficiently
thick
wire
(18
gauge
for
short
lengths,
16-12
gauge
for
longer
lengths).
It
is
recommended
to
use
color-
coded
wire
for
easy
polarity
identification.
Speaker
wires
should
be
as
short
as
possible,
and
the
left
and
the
right
channel
wires
should
be
the
same
length.
Video Component or
TV Tuner
°° To wall
5 outlet
+
Open Reel Tape Right channel Left channel
Deck Speaker System 2
insulation from the end of each wire SS
and twist the strands of each end. -
2. After making sure of the correct — 20mm (8/4 inch)
channel and polarity, loosen the S27
SPEAKER SYSTEM terminal knob
and insert the conductor directly
into the recess at the upper-right of
the terminal. Then tighten the termi-
nal knob, and the end of speaker
wire is automatically wound around
the terminal.
1. Remove about 20 mm (3/4 inch) of
CAUTION: Two speaker systems can
be connected to this unit. When two
speaker
systems
are
connected,
care
should
be
taken
that
the net impedance does not become less than 4 Ohms.