6 REMOTE CONTROL
Remote Control
Independent Remote Control
The system remote of the HK670 can control the
amplifier and compatible Tuners, CD Players and
CD Recorders. The remote In jack of units without
an integrated IR receiver must be connected to
the amplifier's remote control output jack so that
the system remote control can operate them.
The Function Table below will show all functions
of the HK670 and external devices that can be
controlled by the HK670 remote.
Important Notes:
• For controlling a tuner (only needed for the
numeric buttons), CD Recorder or CD Player
the appropriate input ("TUNER", "CDR" or
"CD") must have been selected with the
source buttons of the remote control (selecting
on the front panel is not sufficient).
• Note that DVD players or tape decks cannot
be controlled by the remote.
• To control a compatible CD Recorder "CDR"
must be selected as input and the drive to be
controlled (CDP or CDR) must be selected
appropriately with the "CDP SELECT" or "CDR
SELECT" buttons.
Operating Conditions
The control unit operates effectively within a dis-
tance of 7 meters and an angle of 30° from the
amplifier. Using the control near fluorescent
lights may shorten this range, as will any dust or
dirt that accumulates on the front of the remote
control or the remote sensor area of the amplifi-
er. Also avoid blocking the line of sight between
amplifier and remote.
The control unit is powered by two AA batteries,
included with your amplifier. When you replace
weak batteries, replace both at the same time.
When the remote is to be unused for an extend-
ed period, remove the batteries to prevent dam-
age from corrosion.
Button HK670 CD Player CD Recorder Tuner
POWER/OFF Power On/Off - - -
II
(Fast Forward) - Fast Forward Fast Forward -
HH
(Fast Reverse) - Fast Reverse Fast Reverse -
JH
(Skip Reverse) - Skip Reverse Skip Reverse -
IK
(Skip Forward) - Skip Forward Skip Forward -
A (Stop) - Stop Stop -
I
(Play) - Play Play -
0 ~ 9 (Numeric Buttons) - Track Select Track Select Preset Select
CD Source Select - - -
CDR Source Select - - -
AUX Source Select - - -
TV Source Select - - -
TUNER Source Select - - -
PHONO Source Select - - -
TAPE Source Select - - -
CDP SELECT - - CDP Drive Select
1)
-
CDR SELECT - - CDR Drive Select
1)
-
RDS - - - RDS Display Select
TUNER
D
- - - Tuning Up
TUNER
E
- - - Tuning Down
VOLUME
D
Volume Up - - -
VOLUME
E
Volume Down - - -
1)
Only needed with CD Recorders
Remote button functions
To Next Page
Loading...
