Harman Kardon HK680 - How to Install; General Unit Parts List

/ PH600
PH600 PHONO P.C. BOARD OPTION:
When this option is installed, MM or MC turntables can be connected to the RCA jacks on the Phono PCB. To use the Phono
input, the function selector switch on the front pane! must be set to the AUX2 position. Please note that which the Phono
PCB option installed, signal wires shall not be connected to the AUX2 RCA connectors. Signal applied to the AUX2 input
with the Phono option installed, will be attenuated and may be distorted.
Installation of Optional Phono PCB (PH600):
(Please re-print the information from information sheet you already prepared.)
HOW TO INSTALL
@ Remove 8 screws and then remove the Top Cover of @ Secure the screw removed from the plate and the
HK680. ground terminal screw (included).
@ Remove a screw and a rivet and then remove the plate.
@ For HK680, secure PH600 with a rivet removed from the ® Connect the 2 cables precisely as shown in the illustra-
plate. tion.
GENERAL UNIT GENERAL UNIT PARTS LIST
Ref. No. PartNo. Description
121 2219-8350 METAL FITTG
123 2222-7179 HEAT SINK,Q607,608
125 =: 2347-R0130062 SCREW,BND T+ (3x6 mm)
127: 2347-R0130082 SCREW,BND T+ (3x8 mm) (x2)
23